[NETWORK] menu84 - ENGLISHSettings▶■ Error information pageWhen [Error (Detail)] is displayed on the [Projector status] screen, click it to display the error details.▶z The projector may go into the standby status to protect the projector depending on the contents of theerror.[OK]: Normal operation[FAILED]: Occurrence of trouble[WARNING]: Warning▶zDescription of problem occurrence [FAILED]:Item Description[MAIN CPU BUS] There is a problem with the microcomputer circuitry. Consult yourdealer.[FAN] There is a problem with the fan or the fan drive circuit. Consult yourdealer.[INTAKE AIR TEMPERATURE]The intake air temperature is too high. It may be used in an operatingenvironment where the temperature is high, such as near a heatingappliance, the intake port may be blocked, or the air filter may beclogged.[EXHAUST AIR TEMPERATURE]The exhaust air temperature is too high. The air exhaust port may beblocked, or the mode setting for using the projector at high elevationsmay be wrong.[LAMP REMAIN TIME] The lamp usage time has exceeded the specified time, and it is timeto replace the lamp.[LAMP STATUS] The lamp has failed to turn on. Wait a while until the luminous lampcools off, and then turn on the power.[APERTURE(CONTRAST-SHUTTER)] There is a problem with the contrast shutter circuitry. Consult yourdealer.[INTAKE AIR TEMP.SENSOR] There is a problem with the sensor used to detect intake airtemperature. Consult your dealer.[EXHAUST AIR TEMP.SENSOR] There is a problem with the sensor used to detect exhaust airtemperature. Consult your dealer.[BATTERY] The battery replacement is required. Consult your dealer.[AIR FILTER]There is too much dust accumulated in the air filter unit.Turn the switch to ( page 38), and cleanthe air filter ( page 99).