Panasonic PT-LZ370U Operating Instructions Manual

Also see for PT-LZ370U: Specification Brochure

Contents

[POSITION] menuENGLISH - 57 Settings[DOT CLOCK]▶zOnly for computer (RGB) signal inputUse this function to adjust and minimize the effectof interference caused by projection of patternsconsisting of vertical stripes.The projection of the following striped pattern maycause cyclic patterns (noise). Adjust so that theamount of interference is at a minimum.1) Press ▲▼ to select [DOT CLOCK].2) Press ◀▶ or press the button.▶z The [DOT CLOCK] individual adjustmentscreen is displayed.3) Press ◀▶ to adjust the level.▶z The adjustment values are - 32 to +32.Notez Dot clock adjustment is feasible for computer (RGB)signal input other than 525i (480i), 625i (576i), 525p(480p), and 625p (576p).Attentionz Set it before adjusting [CLOCK PHASE].[CLOCK PHASE]You can adjust to achieve an optimal image whenthere is a flickering image or smeared outlines.1) Press ▲▼ to select [CLOCK PHASE].2) Press ◀▶ or press the button.▶z The [CLOCK PHASE] individual adjustmentscreen is displayed.3) Press ◀▶ to adjust the level.▶z Adjustment value will change between 0 and+31. Adjust so that the amount of interferenceis at a minimum.Notez Optimal value may not be achieved if the outputfrom the input computer is unstable.z To project a signal with dot clock frequency with162 MHz or higher, noise may not disappear even if[CLOCK PHASE] is adjusted.z Adjustment is not available when a 525i (480i) or625i (576i) component (YC BC R ) signal is input.z Adjustment is not available when a 525i (480i) or625i (576i) computer (RGB) signal is input.z [CLOCK PHASE] cannot be adjusted when a digitalsignal is input.