[PROJECTOR SETUP] menu74 - ENGLISHSettings[TEST PATTERN]Displays the test pattern built-in to the projector.Settings of position, size, and other factors will notbe reflected in test patterns. Make sure to display theinput signal before performing various adjustments.1) Press ▲▼ to select [TEST PATTERN].2) Press the button.▶z The test pattern is displayed.3) Press ◀▶ to switch the various testpatterns.▶z Press the button to return to the sub-menu of[PROJECTOR SETUP].▶■ To display sequence of internaltest patternsThe setting will change as follows each time youpress ◀▶ .Horizontal linesAll whiteVertical linesColor barsDotsWhite cross on black backgroundCross hatchBlack cross on white backgroundNotez The default screen is all white. If you assign this tothe to buttons, Cross hatchbecomes the default.[INITIALIZE ALL]You can return various setting values to the factorydefault settings.When you perform this function, the projector entersstandby mode to initialize.1) Press ▲▼ to select [INITIALIZE ALL].2) Press the button.▶z [INITIALIZE ALL] is displayed.▶z Password entry is required if you have set [ON]in the [SECURITY] menu → [PASSWORD]( page 75).3) Press ◀▶ to select [OK].4) Press the button.▶z The [NOW INITIALIZING...] screen appears,and is followed by [POWER OFF.].5) Press the button.▶z Key operations other than the buttonand the power button are unavailable atthis time.6) Wait until the power indicator (G)/STANDBY (R)> of the projectorilluminates or flashes red (the fanstops).7) Press the side of the POWER> switch to turn off the power.▶z The initial setting screen appears the next timethe projector is started. ( page 20)Notez The projector usage time, lamp usage time, and[NETWORK] settings are not initialized.z After performing initialization, the password isreturned to its factory default and [PASSWORD] isset to [OFF].