[POSITION] menu58 - ENGLISHSettings[OVER SCAN]Use the following steps to make adjustments whentext and images on the periphery of the projectedimage are not properly displayed.1) Press ▲▼ to select [OVER SCAN].2) Press ◀▶ or press the button.▶z The [OVER SCAN] individual adjustmentscreen is displayed.3) Press ◀▶ to adjust the level.▶z The adjustment values are 0 to +10.Notez This item is not available for still image computer(RGB) signals.[ASPECT]You can switch the aspect ratio of the image.1) Press ▲▼ to select [ASPECT].2) Press ◀▶ or press the button.▶z The [ASPECT] individual adjustment screen isdisplayed.3) Press ◀▶ to switch the setting.▶z The setting will change as follows each timeyou press the button.▶■ When S-video/video signal isinput[AUTO] [NORMAL] [H FIT][NATIVE] [FULL]Notez [AUTO] is enabled only when an NTSC signal isinput for both S-video and video signals.▶■ When still image computer (RGB)signal is input▶zFor 1280 x 720 input[NORMAL] [S16:9] [NATIVE]▶zFor VGA70, VGA85, 1280 x 768, 1280 x800, WXGA+, or WSXGA+ signal input[NORMAL] [S16:9] [H FIT][NATIVE] [FULL]▶zFor WUXGA input[NORMAL] [S16:9][FULL] [H FIT]▶zFor other still image computer (RGB)signal input[NORMAL] [H FIT][NATIVE]*1 [FULL]*1: UXGA cannot be switched to [NATIVE].▶■ When HDMI signal is input▶zFor 1125 (1080)/60i, 1125 (1080)/50i,1125 (1080)/60p, 1125 (1080)/50p, 1125(1080)/24p input[NORMAL] [S16:9]▶zFor 750 (720)/60p, 750 (720)/50p input[NORMAL] [S16:9] [NATIVE]▶zFor 525p (480p), 625p (576p) input[NORMAL] [H FIT][NATIVE] [FULL]