Panasonic PT-LZ370U Operating Instructions Manual

Also see for PT-LZ370U: Specification Brochure

Contents

[PROJECTOR SETUP] menu70 - ENGLISHSettingsNotez In the following cases, lamp power may not dropautomatically.–▶When [LAMP POWER] is set to [ECO]–▶Immediately after the lamp is turned on orimmediately after setting [LAMP POWER]z If [AUTO POWER SAVE] is [OFF], [AMBIENTLIGHT DETECTION], [SIGNAL DETECTION], and[AV MUTE DETECTION] cannot be set.z The selection made here is reflected to theindication of the “ECO setting level” in the “MultiProjector Monitoring & Control Software” installedfrom the supplied CD-ROM.▶■ When [NO SIGNAL SHUT-OFF]was set in Step 3)The projector enters the standby mode automaticallyif no signal input status maintains. You can set thelatency until the projector enters the standby mode.4) Press ◀▶ to switch [NO SIGNALSHUT-OFF].▶z The setting will change as follows each timeyou press the button.[DISABLE] [15MIN.] [60MIN.][DISABLE] Disables the no signal shut-offfunction.[15MIN.] to[60MIN.]Enables the no signal shut-offfunction. Allows you to set a timein five minute increments.Notez The selection made here is reflected to theindication of the “ECO setting level” in the “MultiProjector Monitoring & Control Software” installedfrom the supplied CD-ROM.z The duration is set to [30MIN.] by default and afteryou perform initialization.▶■ When [STANDBY MODE] was setin Step 3)You can set the power consumption during thestandby.4) Press ◀▶ to switch [STANDBYMODE].▶z The setting will change as follows each timeyou press the button.[ECO] [NORMAL][ECO]Restricts some functions in thestandby mode to reduce powerconsumption.[NORMAL] Does not restrict functionalityeven in the standby mode.Notez If [SCHEDULE] is set to [ON], the setting for[STANDBY MODE] in [ECO MANAGEMENT] isautomatically set to [NORMAL] and cannot bechanged. Even if [SCHEDULE] is then set to [OFF]when in this state, the setting of [STANDBY MODE]remains at [NORMAL].z If set to [ECO], you cannot use network functionswhen the projector is standing by. Also, you cannotuse some protocol commands from terminals. When you turn on the power, projectionof the initial image may be delayed when comparedwith [NORMAL] mode operation.z If set to [NORMAL], you can use network functionswhen the projector is standing by.