Panasonic PT-LZ370U Operating Instructions Manual

Also see for PT-LZ370U: Specification Brochure

Contents

[PROJECTOR SETUP] menuENGLISH - 69 Settings7) Press ▲▼ to select [TIME] or[COMMAND], and change the settingsaccording to the operation instructionsof the menu.[TIME] Sets the time at which the commandwill be executed using ▲▼ .[COMMAND]Selects a command to execute at theset time from the following.[POWER ON][STANDBY][AV MUTE] [ON][OFF][INPUT] [COMPUTER][VIDEO][S-VIDEO][COMPONENT][HDMI 1][HDMI 2][LAMP POWER] [NORMAL][ECO][IN STANDBY MODE] [ON][OFF][VOLUME]8) Press ▲▼ to select [STORE], andpress the button.Notez If you try to register a setting that would cause thelamp to flash for a short time, an error message willbe displayed on the screen and the setting will notbe registered. Set the time and command again.z If multiple commands have been set for the sametime, they are executed in chronological orderstarting from the smallest command number.z The operating time will be the local time. ( page 73)z If an operation is executed with the remote controlor control panel of the projector or with a controlcommand before the command set in [SCHEDULE]is executed, the command set with this functionmay not be executed.[ECO MANAGEMENT]You can optimize lamp power and reduce the powerconsumption according to the application.1) Press ▲▼ to select [ECOMANAGEMENT].2) Press the button.▶z The [ECO MANAGEMENT] screen isdisplayed.3) Press ▲▼▶to select an item.▶■ When [AUTO POWER SAVE] wasset in Step 3)You can enable [AMBIENT LIGHT DETECTION],[SIGNAL DETECTION], and [AV MUTE DETECTION]functions.Notez This setting is not available if [LAMP POWER]( page 68) is set to [ECO].4) Press ◀▶ to switch [AUTO POWERSAVE].▶z The setting will change as follows each timeyou press the button.[ON] [OFF][ON] Enables the auto power savefunction.[OFF] Disables the auto power savefunction.5) Press ▲▼ to select [AMBIENT LIGHTDETECTION], [SIGNAL DETECTION],or [AV MUTE DETECTION].[AMBIENTLIGHTDETECTION]Adjusts the lamp power accordingto the ambient brightness.[SIGNALDETECTION]Drops the lamp power when nosignal is input.[AV MUTEDETECTION]Drops the lamp power in the AVMute mode.6) Press ◀▶ to switch the setting.▶z The setting will change as follows each timeyou press the button.[ON] [OFF][ON] Enables the setting.[OFF] Disables the setting.