Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 11110) Press the button.f The confirmation screen is displayed.11) Press qw to select [OK], and press the button.Notef The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].f The resolution and vertical scanning frequency settings may also be required on your computer or video device.f After configuring settings, your computer or video device or the projector may be required to be turned off and on.f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or videodevice.[SLOT IN]Set this item in accordance with the signal input to the input terminal of the installed Interface Board when theoptional Interface Board is installed in the slot.The content that can be set varies depending on the structure of the installed Interface Board. It cannot be set ifno Interface Board is installed in the slots.When the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installedSetting [HDMI LINK] in [SLOT IN] (HDMI input)1) Press as to select [SLOT IN].2) Press the button.f The [SLOT IN] screen is displayed.3) Press as to select [HDMI LINK], and press the button.f The [HDMI LINK] screen is displayed.4) Press as to select the setting.[AUTO]Automatically selects the single link, the dual link, or the quad link.Selects the quad link when the signal in the same format (such as resolution and timing) is input inthe four inputs of HDMI1, HDMI2, HDMI3, and HDMI4. Selects the dual link when the signal in thesame format is input in the HDMI1 input and the HDMI2 input, or the HDMI3 input and the HDMI4.Quad link will be automatically selected when the optional Interface Board for HDMI 2 input (ModelNo.: ET-MDNHM10) is installed in both of the slots.[SINGLE] Sets the HDMI1 input and the HDMI2 input, and the HDMI3 input and the HDMI4 input to single link.(Factory default setting)[DUAL]*1 Sets the HDMI1 input and the HDMI2 input, or the HDMI3 input and the HDMI4 input to dual link.[DUAL/SINGLE]*2 Sets the HDMI1 input and the HDMI2 input to dual link, and the HDMI3 input and the HDMI4 input tosingle link.[SINGLE/DUAL]*2 Sets the HDMI1 input and the HDMI2 input to single link, and the HDMI3 input and the HDMI4 inputto dual link.[DUAL/DUAL] *2 Sets the HDMI1 input and the HDMI2 input to dual link, and the HDMI3 input and the HDMI4 input todual link.[QUAD] *2 Sets the HDMI1 input, the HDMI2 input, the HDMI3 input, and the HDMI4 input to quad link.*1 This can be selected when the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installed in either of the slots.*2 This can be selected when the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installed in both of the slots.5) Press the button.Notef [HDMI LINK] is fixed to [SINGLE] in the following cases.g When [SIMUL INPUT SETTING] is set to anything other than [OFF]g When the [MULTI DISPLAY] menu → [MULTI DISPLAY MODE] is set to anything other than [OFF] and displaying the four-screen displayf The [HDMI LINK] setting cannot be changed when [BACKUP INPUT MODE] in [BACKUP INPUT SETTING] is set as the combination usedfor the HDMI input of the Interface Board.f The content set is displayed in [HDMI LINK SETTINGS].
