Chapter 4 Settings — [DISPLAY OPTION] menu116 - ENGLISH6) Press qw to switch the item.f The items will switch each time you press the button.[DEFAULT] Standard setting.[USER] Set the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.f When [DEFAULT] is selected, proceed to Step 11).7) Press the button.f The [RESOLUTION] screen is displayed.8) Press asqw to select [RESOLUTION].f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p],[1440x900p], [1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], [1920x1200p],[1920x2160p], [2048x1080p], or [2048x2160p].9) Press the button.f The [VERTICAL SCAN FREQUENCY] screen is displayed.10) Press qw to select [VERTICAL SCAN FREQUENCY].f Select [30Hz], [25Hz], or [24Hz] when [2048x2160p] or [1920x2160p] is selected for [RESOLUTION].f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [2048x1080p] or [1920x1080p] is selected for[RESOLUTION].f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].g [2048x2160p], [1920x2160p], [2048x1080p], [1920x1080p], [1920x1080i]11) Press the button.f The confirmation screen is displayed.12) Press qw to select [OK], and press the button.Notef The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].f The resolution and vertical scanning frequency settings may also be required on your computer or video device.f After configuring settings, your computer or video device or the projector may be required to be turned off and on.f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or videodevice.When the optional 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G) is installedTo use the 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G), it is necessary for the firmware version ofthe 3G-SDI Terminal Board with Audio to be 2.00 or later. Consult your dealer regarding the version update to thelatest firmware if the version is earlier than 2.00.For details on how to confirm the firmware version, refer to “How to confirm the firmware version of the 3G-SDITerminal Board with Audio” (x page 31).Setting [SDI LINK] in [SLOT IN] (SDI input)1) Press as to select [SLOT IN].2) Press the button.f The [SLOT IN] screen is displayed.3) Press as to select [SDI LINK], and press the button.f The [SDI LINK] screen is displayed.4) Press as to select the setting.[AUTO]Automatically selects the single link, the dual link, or the quad link.The single link, dual link, or quad link is automatically distinguished by reading the payload IDattached to each input signal. Single link will be selected when a payload ID is not added to the inputsignal.Quad link will be automatically selected when the optional 3G-SDI Terminal Board with Audio (ModelNo.: TY-TBN03G) is installed in both of the slots.
