Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 57Initial setting (operation setting)Set the items for the operating method depending on the projector’s application and duration of usage.After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP]menu. If you change the settings while using the projector, the duration until the luminance of light sourcedecreases by half may shorten or the luminance may decrease.By using this initial setting (operation setting), you can complete the settings at once when installing the projector,if the operation method of the projector is determined in advance. If [ALL USER DATA] is executed from the[PROJECTOR SETUP] menu → [INITIALIZE], do not change the initial setting (operation setting) and proceed tonext initial setting (installation setting) by pressing the button. If you need to change the setting, ask theperson responsible for this projector (such as a person in charge of equipment or operation).2/7100%100%INITIAL SETTINGSETCHANGEMENU SELECTOPERATING MODECONSTANT MODENORMALOFFLINK GROUP AENTERCALIBRATION TIME OFFCALIBRATION MESSAGE ONBRIGHTNESS CONTROL SETUPLIGHT OUTPUTMAX LIGHT OUTPUT LEVELSet the way to use the projector. For details, pleaserefer to the operating instructions "When the initialsetting screen is displayed".Notef The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. If [ALL USER DATA] isexecuted from the [PROJECTOR SETUP] → [INITIALIZE], the settings before execution are displayed in [OPERATING MODE] and [MAXLIGHT OUTPUT LEVEL].f For the relationship between the luminance and the runtime, refer to “Interrelation of luminance and runtime” (x page 59).f For details on each setting item, refer to the [PROJECTOR SETUP] menu → [OPERATION SETTING].1) Press as to select [OPERATING MODE].2) Press qw to switch the item.f The items will switch each time you press the button.f Set [OPERATING MODE] to anything other than [ECO], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3]when using the projector at an altitude of 2 700 m (8 858') or higher above sea level.[NORMAL] *1 Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours.[ECO] *1 Set this item to increase the life of the light source though it will lower the luminance than [NORMAL].The estimated runtime is approximately 24 000 hours.[LONG LIFE1]*1 Set this item to increase the life of the light source though it will lower the luminance than [ECO]. Theestimated runtime is approximately 43 000 hours.[LONG LIFE2]*1 Set this item to increase the life of the light source though it will lower the luminance than [LONGLIFE1]. The estimated runtime is approximately 61 000 hours.[LONG LIFE3]*1 Set this item to increase the life of the light source though it will lower the luminance than [LONGLIFE2]. The estimated runtime is approximately 87 000 hours.[USER1]Set [MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] individually.[USER2][USER3]*1 The runtime is estimated when the [PICTURE] menu → [DYNAMIC CONTRAST] is set to [3].f When [NORMAL], [ECO], [LONG LIFE1], [LONG LIFE2], or [LONG LIFE3] is selected, proceed to Step 5).3) Press as to select [MAX LIGHT OUTPUT LEVEL].4) Press qw to adjust.Operation Adjustment Range of adjustmentPress w. Increases the maximum level of brightness correction. 8.0 % - 100.0 %Press q. Decreases the maximum level of brightness correction.5) Press as to select [LIGHT OUTPUT].
