Chapter 4Settings—[SECURITY] menu158 - ENGLISH4)Press the button.fThe[CONTROL PANEL]screen or the[REMOTE CONTROL]screen is displayed.5)Pressasto select [CONTROL PANEL] or [REMOTE CONTROL].6)Pressqwto switch [USER].7)Pressasto select the button item to set.fWhen [INPUT SELECT BUTTON] is selected, press the button, and then pressasto selectthe button to set.Buttons that can be set[CONTROL PANEL][REMOTE CONTROL][POWER BUTTON]Power standby <v> button, power on <b> button[INPUT SELECT BUTTON] button, button, LINK> button, 1> button, 2>button, button button, button, button, button, 1> button,2> button, button[MENU BUTTON][LENS BUTTON] buttonLens buttons (, , )[AUTO SETUP BUTTON] button[SHUTTER BUTTON] button[ASPECT BUTTON]― button[ON SCREEN BUTTON]― button[OTHER BUTTON]asqw, buttonButtons not listed above8)Pressqwto switch the item.[ENABLE]Enables button operations.[DISABLE]Disables button operations.fWhen [INPUT SELECT BUTTON] is selected in Step7), the item that can be set varies depending on theselected button.Refer to “Item that can be set with [INPUT SELECT BUTTON]” (xpage158) for details.Once the switching of the item is completed, press the [CONTROL PANEL]screen or the[REMOTE CONTROL]screen.9)Pressasto select [APPLY], and press the button.fThe confirmation screen is displayed.10)Pressqwto select [OK], and press the button.NotefWhen a button operation is performed on the device set to [DISABLE], the[CONTROL DEVICE PASSWORD]screen is displayed.Enter the control device password.fThe[CONTROL DEVICE PASSWORD]screen will disappear when there is no operation for approx. 10 seconds.fIf the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannotenter standby).fWhen the setting has completed, the menu screen will disappear. To operate continuously, press the menu.fEven when you set button operations on the remote control disabled, operations of the and buttons on the remotecontrol are kept enabled.Item that can be set with [INPUT SELECT BUTTON]When [INPUT SELECT BUTTON] is selected in Step7)of “Enabling/disabling any button” (xpage157), theitem that can be selected varies depending on the button to set.The item that can be selected when each button is set is as follows.r[SDI1/2 BUTTON][TOGGLE]Switches between [SDI1] and [SDI2] when the button is operated.[SDI1]Fixes to selection operation of the SDI1 input.[SDI2]Fixes to selection operation of the SDI2 input.[DISABLE]Disables button operations.
