Panasonic System 850 Operating Instructions Manual

Also see for System 850: Brochure

Contents

107Camera Function Control Camera SetupThe following function requires the use of camerasequipped with this specific feature.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Pressing the [STOP] button while holding down the[SHIFT] button will open the Camera Setup Menu onthe active monitor.The STOP indicator will light.3. Select the desired item in the menu by moving theJoystick Controller UP and DOWN, and then select thedesired parameter (or mode) in the menu by movingthe Joystick Controller L and R.Press the [CAMERA (ENTER)] button to execute thecurrently highlighted selection and to enter a submenuof the Camera Setup Menu, or press the [CLEAR(ESC)] button to leave from the currently selectedmenu and return to the previous page of the menu.4. Press the [RESET] button in the menu to reset theparameter of a selected item to the factory default set-ting or enter the Special Camera Menu when the cursoris positioned on SPECIAL in the menu.Pressing the [RESET] button while holding down the[SHIFT] button will restore all factory default settings.Notes:• Refer to the Operating Instructions of the selectedcamera for more details.• Moving the joystick while holding down the [SHIFT]button will move the camera smoothlyfor presettingthe position in the camera setup menu.5. To close the Camera Setup Menu, press the [PAUSE]button while holding down the [SHIFT] button.The STOP indicator will go off. Camera Function (ShortcutFunction)The following function is available only when specified cam-eras with the camera function feature are used.This function enables executing camera functions via ashortcut.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Press the [F2] button.“F----” as shown in the figure will appear on the LEDdisplay of the controller.3. Select an assigned function number by pressing thenumeric buttons, then press the [CAMERA (ENTER)]button.For example, enter 175 for AGC On.The selected function will be executed on the activemonitor.Note: For further information, refer to the OperatingInstructions for that camera.4. To exit from the mode, press the [CLEAR (ESC)] but-ton.RESETACKALARMDISARM ALL RESETNEXTPREVS-CTL IDSTOPPAUSECAM MENU ONCAM MENU OFFTOURSEQGROUPSEQMONITORLOCKOSD SERVICECAM FUNCOSDOPE IDGROUP PRESETLOG OUTF1F2PROGRAMPRESETCALLPRESETAUX1 OFFALM SCAM IDT&DAUX1 ONVLD SGENWIPERSYS SAUX2 OFFALM HAUX2 ONVDL HALLSHIFT BLK EXITCLEAR(ESC)DEF OFF DEF ONCAMERA(ENTER)AUTOPANMON STATUS RESETACKALARMDISARM ALL RESETNEXTPREVS-CTL IDSTOPPAUSECAM MENU ONCAM MENU OFFTOURSEQGROUPSEQMONITORLOCKOSD SERVICECAM FUNCOSDOPE IDGROUP PRESETLOG OUTF1F2PROGRAMPRESETCALLPRESETAUX1 OFFALM SCAM IDT&DAUX1 ONVLD SGENWIPERSYS SAUX2 OFFALM HAUX2 ONVDL HALLSHIFT BLK EXITCLEAR(ESC)DEF OFF DEF ONCAMERA(ENTER)AUTOPANMON STATUS