83 Pan/Tilt Control(Program Preset Position)The following function requires the use of camerasequipped with this specific feature.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Move the camera to the position to be preset by mov-ing the Joystick Controller and pressing the lens controlkeys.3. Select the desired preset position number by pressingthe numeric keys.4. Holding down the [PGM PRESET] key, and then pressthe [CAMERA (ENTER)] key to save a preset positionof the camera.Note: If the position number entered has been storedpreviously, the old position will be overwritten bythe new one. Pan/Tilt Control (Call Preset Position)The following function requires the use of camerasequipped with this specific feature.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Select the preset position number by pressing thenumeric keys.3. Press the [CALL PRESET] key to move to the presetposition of the selected camera on the active monitor.Note: To be able to use the above function, the presetposition number must have been set for that cam-era. Pan/Tilt Control(Camera Position Operation)The following function requires the use of camerasequipped with this specific feature.1. Select the desired monitor.Refer to the Monitor Selection.2. Select the desired Camera Position Number by press-ing the numeric keys, then press the [CAM POSI] keyto move the camera to the preset position.The selected camera position appears on the activemonitor.Note: To use the above function, it is necessary to reg-ister the preset position number with the cameranumber in the Administration Console in advance.INFORMATIONEntry:48INFORMATIONPrg Preset48LOGOUTAUX1 OFF AUX1 ONCALLPRESET PGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXITINFORMATIONEntry:52INFORMATIONPreset 52LOGOUTAUX1 OFF AUX1 ONCALLPRESET PGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXITINFORMATIONEntry:128INFORMATIONCam Posi 128LOGOUTAUX1 OFF AUX1 ONCALLPRESET PGMPRESETC A MP O S ID I G I TA LO U TDEF OFF DEF ONAREAAUX2 OFF AUX2 ONCAMERA(ENTER)AUTO PANCAM IDVLD ST&DALM S GENSYS S(ALARM)087MSTATUSVLD HALLALM HBLK59642 31SHIFTCLEAR(ESC)EXIT