Panasonic System 850 Operating Instructions Manual

Also see for System 850: Brochure

Contents

104Controlling Camera Site AccessoriesControls for camera site accessories are located on theright side of the front panel of the System Controller.Included are Zoom Control, Focus Control, Iris Control,Preset and Pan/Tilt Controls. Normally, combination cam-eras equipped with the specific feature or a WV-RC100 orWV-RC150 Receiver are required to utilize these functions. Lens ControlNote: Confirm that the specified lens, with powerzoom/focus functions, is mounted on the camera. Alsoconfirm that the Lens Selection (DC/VIDEO) on thecamera is set to the DC position.Function capabilities vary between cameras. Referringto the operating instructions of each camera is recom-mended.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Press the [FOCUS NEAR/FAR] buttons while observ-ing the monitor to adjust the lens focus to achieve asharply focused picture.By pressing these buttons at the same time, the lensfocus is set automatically, if the specified camera withthe auto focus feature is used.3. Press the [ZOOM TELE/WIDE] buttons while observingthe monitor to adjust the lens zoom to achieve thedesired picture.Press the [TELE] button to optically bring an objectcloser. Pressing the [WIDE] button has the reverseeffect.4. Press the [IRIS CLOSE/OPEN] buttons to close/openthe lens iris. Adjust the lens iris by using these buttonsto obtain the proper picture exposure.By pressing these buttons at the same time, the lensiris is reset to the factory default setting. Pan/Tilt Control Pan/Tilt Control (Manual Operation)1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Move the Joystick Controller to move the Pan/Tilt Headtowards the desired direction.If the joystick is positioned in between UP and R, thePan/Tilt Head moves diagonally towards Up and Right.Eight directions are available: Up / Down / Right / Left /Up-Right / Up-Left / Down-Right / Down-left. Pan/Tilt Control (Auto Panning)The following function requires the use of camerasequipped with this specific feature.1. Select the desired monitor and camera.Refer to the Monitor Selection and Camera Selection.2. Pressing the [CAMERA (ENTER)] button while holdingdown the [SHIFT] button will activate the Auto Panningfunction of the selected camera.3. To cancel the auto panning function, move the JoystickController.FOCUSFARNEARAUTO FOCUSZOOMTELEWIDEIRISOPENCLOSEAUTO IRISUPL RDOWNPROGRAMPRESETCALLPRESETAUX1 OFFALM SCAM IDT&DAUX1 ONVLD SGENWIPERSYS SAUX2 OFFALM HAUX2 ONVDL HALLSHIFT BLK EXITCLEAR(ESC)DEF OFF DEF ONCAMERA(ENTER)AUTOPANMON STATUS