Raymarine ST70+ Operating Manual

Also see for ST70 Instrument: Installation guide User reference guide User reference handbook Installation guide Operating guide

Contents

Raymarine ST70+ Operating Manual Manual pdf 25 page image

Chapter 2: Commissioning Procedures 1713. When all displays are set as you want, and with the Configure this display pagedisplayed, press MENU, to leave the Setting display types and groups procedure,and display either:• A Time & date summary page, if your system provides GPS information,• or• A Units Summary page if GPS information is not available.Date & TimeThe Time & Date summary page shows the currentvalues applied to your ST70+ system.Note: If your display is not receiving GPS information, the Time& Date page is not displayed. In this case, proceed withthe Data units setup procedure below.Check the information, on the Time & Date summarypage, then press OK to display the Time & Datesetup menu.You can change certain date and time parameters. You can:• Select either dd/mm/yy or mm/dd/yy as the date format• Select either 12-hour (am/pm) or 24-hour as the time format.• Set the value of the time offset to give the required local time.If you want to change any Time & Date values, carry out the Setting date format,Setting time format and/or Setting local time procedure below, as appropriate.If you do not want to change any Time & Date values, proceed from Leaving date &time setup below.Setting date formatTo set the required date format:1. At the Time & Date setup menu, scroll to the Setdate format option, then press OK to display theSet date format page.2. Scroll to select the required Date Format, thenpress OK to save the format and return to theTime & Date summary page.3. Press OK to select the Time & Date setup menu.iD11149-1Press OK to continueTime & DateThese are your current settings.10 Time 11:01:03Date 14/06/07Time Offset -1 HrsTime Format 24-hourDate Format dd/mm/yyD11153-1Time & DateSet date formatPress OK to select10iD11154-1Press OK to acceptSet date formatUse < & > to adjust.CANCEL exits without saving.dd/mm/yy10