66 ST70+ User Reference ManualAbout PilotIf the display is set as a Pilot Controller, carry out the following check:1. With the Diagnostics menu displayed, scroll to select the About pilot option, thenpress OK, to display the About pilot page. This shows:2. Note that:• Temperature should be in the range -30°Cto +70°C• Volts (CAN) should be 12 V• Volts should be in the range 9 V to 16 V3. Make a note of any data you need then pressOK:.• If there is no more data to be displayed, thedisplay shows the Diagnostics menu.• If there is more data to be displayed, the next page of About Display data is dis-played. Repeat step 3 until the display shows the Diagnostics menu.Product supportRaymarine provides a comprehensive customer support service, on the world wideweb and by telephone help line. Please use either of these facilities if you are unableto rectify a problem.World wide webPlease visit the Customer Support area of our web site at:www.raymarine.comAs well as providing a comprehensive Frequently Asked Questions section andservicing information, the web site gives e-mail access to the Raymarine TechnicalSupport Department and a details of the locations of Raymarine agents, worldwide.Telephone help lineIf you do not have access to the world wide web, please call our help line.In the USA, call:• +1 603 881 5200 extension 2444In the UK, Europe the Middle East or the Far East, call:• +44 (0) 23 9271 4713 (voice)• +44 (0) 23 9266 1228 (fax)• Time since power on. • Temperature• NMEA manufacturer’s product code • Voltage• Raymarine product description. • Peak voltage• Raymarine product identity • Current• Software Version Number • Peak current• Hardware Version Number • Total hours run• Bootloader Version NumberD11408-1Press OK to continueAbout PilotRun TimeSoftware Ver.Bootloader Ver.Hardware Ver.TemperatureVolts (CAN)VoltsV0.20V2.00V0.1035.20 C12.0 V12.26 V85.00Up Time 3.50