Tascam DP-32 Digital Portastudio Owner's Manual

Also see for DP-32 Digital Portastudio: Troubleshooting supplement Schematic diagram

Contents

Tascam DP-32 Digital Portastudio Owner's Manual Manual pdf 44 page image

44 TASCAM DP-326 - Basic RecordingDIGITAL TRIM setting (track only)Depending on the playback sound, EQ boosting couldcause distortion (digital clipping). If this happens, use theDIGITAL TRIM to lower the playback level before the EQ.1. Use the CURSOR (5/b/g/t) buttons to move thecursor to the DIGITAL TRIM display area.Digital trim2. Turn the JOG/DATA dial to set the value.Setting range: -42dB to +6dB (Default: 0dB)Sending signals to internal/externaleffectsThis unit has two external effect sends (EFF 1 and EFF 2)and a send for the internal effects (INSERT EFFECT).You can adjust send levels for each track. For details aboutthe built-in send effects, see "Send effects" on page 63.Follow these procedures to enable use of theseeffects.1. Use the CURSOR (5/b/g/t) buttons to move thecursor to the SEND EFF 1/EFF 2 area.Effect sends2. Turn the JOG/DATA dial to enable the effect.Options: OFF (default), PRE, POSTPREThis sends the track pre-fader signal to the effectsend bus. The effect send signal level is not affectedby the track fader.POSTThis sends the track post-fader signal to the effectsend bus. The effect send signal level is affected bythe track fader.3. Use the SEND EFF 1/EFF 2 knobs to adjust theexternal send levels.Setting range: 0 to 127 (Default: 0)4. Use the SEND MASTER 1/MASTER 2 knobs to adjustthe internal send levels.Setting range: 0 to 127 (Default: 0)Enabling insert effectsThis unit has dynamic and guitar effects that can beused as insert effects. For details about these effects, see"Dynamic effects" on page 61 and "Guitar effects" on page62.1. Use the CURSOR (5/b/g/t) buttons to move thecursor to the INSERT EFFECT area.Insert effectindicator2. Turn the JOG/DATA dial to enable/disable theinsert effect.OptionsOFF: INSERT EFFECT indicator unlit (default)ON: INSERT EFFECT indicator litSetting the stereo positionUse the PAN parameter to set the stereo position.The full left value is L63, and the full right value is R63.The center position is shown by C.PANTurn the PAN knob to adjust the stereo position.Setting range: L63 to C to R63 (Default: C)