Tascam DP-32 Digital Portastudio Owner's Manual

Also see for DP-32 Digital Portastudio: Troubleshooting supplement Schematic diagram

Contents

Tascam DP-32 Digital Portastudio Owner's Manual Manual pdf 57 page image

TASCAM DP-32 578 - Track EditingIn the past, editing recordings made on tape recordersrequired advanced techniques, but with this unit editingis easy and accurate.Moreover, unlike with a tape recorder when an editingerror could not be undone, this unit uses non-destructiveediting, which means you can edit without altering theoriginal data so the undo function can be used to correctan edit easily. (See "Undoing an operation" on page 47.)Overview of track editingThis unit has the following track editing functions.• COPY/PASTE• COPY/INSERT• MOVE/PASTE• MOVE/INSERT• OPEN (insert silence)• CUT (remove part)• SILENCE (erase part)• CLONE TRACK (duplicate track)• CLEAN OUT (delete track)Editing pointsThe IN, OUT and TO points are used as editing points forthe COPY/PASTE, COPY/ INSERT, MOVE/PASTE and MOVE/INSERT functions.The IN and OUT points are used as editing points for theOPEN, CUT, and SILENCE functions.These are the same IN and OUT points used for repeatplayback.ª IN pointThe IN point is the start point for the part of the track tobe edited.Press and hold the MARK SET button and press the INbutton to set the IN point at the current position.ª OUT pointThe OUT point is the end point for the part of the track tobe edited.Press and hold the MARK SET button and press the OUTbutton to set the OUT point at the current position.ª TO pointThe TO point is the current playback position.NOTEIf you press the JOG PLAY button to enable jog mode, youcan set IN and OUT points with subframe (1/10 frame)precision.Basic editing procedures1. When the recorder is stopped, press the TRACKEDIT button to open the TRACK EDIT menu.2. Use the JOG/DATA dial or the CURSOR (5/b)buttons to select (highlight blue) the desired trackediting function, and then press the F4 (t) button.The corresponding function window opens.COPY PASTE window3. Select the setting item value.If there are multiple setting items, use the CURSOR(5/b) buttons to select one, and then use the JOG/DATA dial to set the value.4. Press the F2 (YES) button to execute the function.NOTEPress the F1 (NO) button to close the COPY PASTE windowwithout executing the function.Explanation of itemsª SOURCEThis is the track to be edited.The choices available depend on the editing function.• 1 to 12: Single track• 13/14 to 31/32: Stereo trackYou can also use track SELECT buttons to set this.• ALL: Every track from 1 to 32COPY PASTE window