Copy WorkCentre ® 5945/5955User Guide 81• 100% / 100% will keep your output image the same size as your original. This option isuseful if you are programming a complex job and want to cancel any reduce or enlargesettings without cancelling other settings you have made.• Auto Independent X-Y% automatically fits the image of your original onto the paper youhave selected. The reduction or enlargement may not be proportional, the device willdistort the image so that it will fit onto the paper.Note: If you have not yet selected a paper size you will be prompted to select a size when youselect the Auto Independant X-Y% option.Note: You must specify a paper tray before using this option.9. Select the OK button.10. Enter the number of prints required using the numeric keypad on the control panel.11. Press the Start button on the control panel to scan the original.12. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.13. Press the Job Status button on the device control panel to view the job list and check the statusof the job.14. If your job remains held in the Active Jobs list, the device needs you to supply additionalresources, such as paper or staples before it can complete the job. To find out what resourcesare needed, select the job and then select the Details button. Once the resources are availablethe job will print.More InformationReducing or Enlarging Copies by Proportional %Using a User ID to Log In at the DeviceUsing Internet Services to find System Administrator Contact DetailsViewing the Progress and Details of a Job using the Job Status MenuSetting the Paper Supply for CopiesSetting the Paper Supply for CopiesWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.Use the Paper Supply options to select a specific paper tray for your job, or to allow the device toAuto Select a tray.Auto Select automatically selects the appropriate paper size for each original based on the size ofthe original and any reduce or enlarge programming you have chosen. Alternatively, you can selecta paper tray that contains the size and type of paper you require.
