Copy WorkCentre ® 5945/5955User Guide 9312. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.13. Press the Job Status button on the device control panel to view the job list and check the statusof the job.14. If your job remains held in the Active Jobs list, the device needs you to supply additionalresources, such as paper or staples before it can complete the job. To find out what resourcesare needed, select the job and then select the Details button. Once the resources are availablethe job will print.More InformationUsing a User ID to Log In at the DeviceViewing the Progress and Details of a Job using the Job Status MenuImage OptionsChoosing the Image Options for CopiesWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.The Image Options features give you choices for changing the appearance of the output.Use the Lighten / Darken options to manually adjust the lightness or darkness of the image. Lightoriginals containing pencil images may produce better output if the darkness is increased. Darkoriginals such as halftones or documents with colored backgrounds may need to be lightened.Use the Sharpness option to manually control the sharpness of the scanned images.1. Load your documents face up in the document feeder input tray. Adjust the guide to just touchthe documents.OrLift up the document feeder. Place the document face down onto the document glass andregister it to the arrow at the top left corner. Close the document feeder.2. Press the Clear All button on the control panel to cancel any previous programming selections.3. Press the Services Home button.4. Select the Copy button on the touch screen. The copy features are displayed.5. Select the Image Quality tab.6. Select the Image Options button.7. Select the option(s) required.8. Select the OK button.9. Enter the number of prints required using the numeric keypad on the control panel.10. Press the Start button on the control panel to scan the original.11. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.
