Copy WorkCentre ® 5945/5955User Guide 877. Select the Collation option required.• Collated sorts your copies into sets 1,2,3 1,2,3 1,2,3.• Uncollated sorts your copies into stacks 1,1,1 2,2,2 3,3,3.8. Enter the number of prints required using the numeric keypad on the control panel.9. Press the Start button on the control panel to scan the original.10. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.11. Press the Job Status button on the device control panel to view the job list and check the statusof the job.12. If your job remains held in the Active Jobs list, the device needs you to supply additionalresources, such as paper or staples before it can complete the job. To find out what resourcesare needed, select the job and then select the Details button. Once the resources are availablethe job will print.More InformationUsing the None Output Option for CopiesStapling CopiesHole Punching CopiesPreparing Copies to be made into a BookletUsing a User ID to Log In at the DeviceViewing the Progress and Details of a Job using the Job Status MenuStapling CopiesWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.Depending on the optional finishing device and kits installed you will have the choice of differentoutput options such as stapling, folding and collating.Use the stapling options to staple your document. The options available are dependent on thefinishing device installed. The basic stapling options are Off, 1 Staple, 2 Staples and Multi-Staple.1. Load your documents face up in the document feeder input tray. Adjust the guide to just touchthe documents.OrLift up the document feeder. Place the document face down onto the document glass andregister it to the arrow at the top left corner. Close the document feeder.2. Press the Clear All button on the control panel to cancel any previous programming selections.3. Press the Services Home button.4. Select the Copy button on the touch screen. The copy features are displayed.5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.6. If required, select the More... button at the bottom of the Copy Output section to access all thefinishing options. The number of options displayed will depend upon the finishing device andkits installed (there may not be enough to require a More... button).
