Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-77WorkCentre 7132 005-147, 005-150Status-indicator-rapsRevisionCheck the wire between J765 and J755 for an open circuit or a short circuit (BSD 5.5 Flag2). The wire between J765 and J755 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB P755-1 (+) and GND (-), and betweenP755-6 (+) and GND (-) (BSD 5.5 Flag 2). The voltage is approx. +24VDC.Y NReplace the DADF PWB (PL 16.3).Replace the DADF Registration Motor (PL 16.9) If the problem persists, replace theDADF PWB (PL 15.3).Execute Component Control [005-072]. The Exit Nip Release Solenoid can be heard.Y NCheck the connections of P/J766 and P/J756. P/J766 and P/J756 are connected cor-rectly.Y NConnect P/J766 and P/J756.Check the wire between P756 and J766 for an open circuit or a short circuit (BSD 5.6 Flag2). The wire between P756 and J766 is conducting without an open circuit or ashort circuit.Y NRepair the open circuit or short circuit.Replace the Exit Nip Release Solenoid (PL 16.4) If the problem persists, replace theDADF PWB (PL 16.3).Replace the DADF PWB (PL 16.3).005-150 CVT Holed Paper Feed Sensor Off JamBSD-ON:5.4Feed Sensor does not turn Off in specified time from Feed Sensor On in holed documentmode.ProcedureEnsure that a point on circumference (farthest from trail edge), not a center, of a hole on trailedge side is 19mm or less from trail edge.A B