Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-133WorkCentre 7132 012-161Status-indicator-rapsRevision012-161 Finisher Set Eject Jam RAPBSD-ON:12.4/12.7After the Eject Motor turned On, the Compile Paper Sensor (PL 16.9did not turn Off within thespecified time.Initial Actions• Power Off/OnProcedureExecute Component Control [012-151 Compile Paper Sensor]. Actuate the Compile PaperSensor with paper. The display changes.Y NCheck the connections of P/J8806 and P/J8848. P/J8806 and P/J8848 are con-nected correctly.Y NConnect P/J8806 and P/J8848.Check the wire between J8806 and J8848 for an open circuit or a short circuit (BSD 12.4Flag 3/Flag 4). The wire between J8806 and J8848 is conducting without an opencircuit or a short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8848-A6 (+) and GND (-) (BSD 12.4Flag 4). The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 17.12).Measure the voltage between the Finisher PWB P8848-A5 (+) and GND (-) (BSD 12.4Flag 3).Actuate the Compile Paper Sensor with paper. The voltage changes.Y NReplace the Compile Paper Sensor (PL 17.9).Replace the Finisher PWB (PL 17.12).Alternately execute Component Control [012-081 Eject Motor FORWARD ON] and ComponentControl [012-082 Eject Motor REVERSE ON]. The Eject Motor starts up.Y NCheck the connections of P/J8801 and P/J8846. P/J8801 and P/J8846 are con-nected correctly.Y NConnect P/J8801 and P/J8846.Check the wire between J8801 and J8846 for an open circuit or a short circuit (BSD 12.7Flag 5). The wire between J8801 and J8846 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Eject Motor between J8801-2/5 (COM) and each point ofJ8801-1/3/4/6 (BSD 12.7 Flag 5). The resistance is approx. 2Ohm.Y NReplace the Eject Motor (PL 17.7).Measure the voltage between the Finisher PWB P8846-6 (+) and GND (-), and betweenP8846-12 (+) and GND (-) (BSD 12.7 Flag 5). The voltage is approx. +24VDC.Y NReplace the Finisher PWB (PL 17.12).Replace the Eject Motor (PL 17.7). If the problem persists, replace the Finisher PWB (PL17.12).Replace the Finisher PWB (PL 17.12).AABB