Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20074-204 WorkCentre 7132REP 22.5.1, REP 22.5.2Reversion 4.0Repairs/AdjustmentsREP 22.5.1 Pinch RollParts List on PL 22.5RemovalWARNINGTo avoid personal injury or shock, do not perform repair or adjustment with electricalpower applied to the machine.CAUTIONBefore turning OFF the power switch, note the following to prevent loss of customer data.[with the FAX function]Check that the “Job in Memory” lamp is off. Press the “Job Status” button and check that no jobis in progress.[with the Printer function]Check that “Ready to print/send” is displayed on the Control Panel.1. Remove the A-Finisher from the machine.2. Remove the Compile Assembly. (REP 22.9.1)3. Remove the Pinch Roll. (Figure 1)(1)Raise Springs (4) in the direction of the arrow.(2)Remove Pinch Rolls (4).Figure 1 Removing the Pinch Rolls (j0fa42224)Replacement1. Reverse the removal procedure for replacement.REP 22.5.2 Finisher Entrance SensorParts List on PL 22.5RemovalWARNINGTo avoid personal injury or shock, do not perform repair or adjustment with electricalpower applied to the machine.CAUTIONBefore turning OFF the power switch, note the following to prevent loss of customer data.[with the FAX function]Check that the “Job in Memory” lamp is off. Press the “Job Status” button and check that no jobis in progress.[with the Printer function]Check that “Ready to print/send” is displayed on the Control Panel.1. Remove the A-Finisher from the machine.2. Turn over the A-Finisher.3. Remove the Bottom Cover. (PL 22.2)4. Remove the Connector Bracket. (Figure 1)(1)Release Clamps (3) and remove the wire.(2)Disconnect Connectors (5).(3)Remove Screws (2).(4)Remove Connector Bracket.Figure 1 Removing the Connector Bracket (j0fa42266)5. Remove the Bottom Plate. (Figure 2)