Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-94 WorkCentre 7132005-285, 005-286RevisionStatus-indicator-rapsY NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB P786-1 (+) and GND (-) (BSD 5.2 Flag 5).The voltage is approx. +24VDC.Y NReplace the DADF PWB (PL 16.3).Replace the DADF Nudger Motor (PL 16.6) If the problem persists, replace the DADFPWB (PL 16.3).Replace the DADF PWB (PL 16.3).005-286 DADF Feed Out Sensor RAPBSD-ON:5.4During document transport, before the DADF Feed Out Sensor turned Off, the DADF Pre Reg-istration Sensor turned Off.Initial ActionsPower Off than OnProcedureExecute Component Control [005-205]. Actuate the DADF Feed Out Sensor with paper. Thedisplay changes.Y NCheck the connections of P/J769 and P/J758. P/J769 and P/J758 are connected cor-rectly.Y NConnect P/J769 and P/J758.Check the wire between J769 and J758 for an open circuit or a short circuit (BSD 5.4 Flag13/Flag 14). The wire between J769 and J758 is conducting without an open circuitor a short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB P758-3 (+) and GND (-) (BSD 5.4 Flag14). The voltage is approx. +5VDC.Y NReplace the DADF PWB (PL 16.3).Measure the voltage between the DADF PWB P758-2 (+) and GND (-) (BSD 5.4 Flag13).Actuate the DADF Feed Out Sensor with paper. The voltage changes.Y NReplace the DADF Feed Out Sensor (PL 16.9).Replace the DADF PWB (PL 16.3).Execute Component Control [005-206]. Actuate the DADF Pre Registration Sensor with paper.The display changes.Y NCheck the connections of P/J781 and P/J761. P/J781 and P/J761 are connected cor-rectly.Y NConnect P/J781 and P/J761.Check the wire between J781 and J761 for an open circuit or a short circuit (BSD 5.4 Flag3/Flag 4). The wire between J781 and J761 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.AA B