Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20076-3WorkCentre 7132 UI Diagnostic ModeGeneral procedures informationReversion 4.0UI Diagnostic ModeProcedureAccess UI Diagnostics by following the procedures below.Entering UI Diagnostics1. At the Control Panel, press and hold the 0 key for 5 seconds, then press the Start buttonwhile still pressing the 0 key.The CE Mode - Password Entry screen will appear.2. Enter the Access Number 6789 and press Confirm.The colors on the display are reversed to indicate that UI Diagnostics mode is active.Accessing Diagnostic routines1. Press the Log In/Out button on the Control Panel.2. Select System Settings.3. Select Common Settings.4. Select Maintenance/Diagnostics.5. The following Diagnostics Routines can be accessed from the UI screen. (Figure 1)a. NVM Read/Write– Follow the instructions on the screen. If one or more NVM locations is changed,the machine will reboot upon exit.b. Component Controlc. Sub System– Initialize Hard Disk– Delete All Data– Software Options– Fax Diagnosticsd. Print Test Patterne. Initialize NVMf. Adjustment/Others– Machine ID/Billing Data– Initialize HFSI Counter– Adjust Toner Density– Tray 5(Bypass) Guide Adjustment (Tray 5=MPT)Figure 1 Maintenance/DiagnosticsMaintenance / DiagnosticsNVM Read / WriteIO CheckSub SystemComponent ControlAnalog MonitorSize Detection Auto AdjustHard Disk FailurePrediction TestFax DiagnosticsInitialize Hard DiskBlank Page ThresholdValueDelete All DataSoftware OptionsPrint Test PatternInitialize NVMProcon on/off PrintIIT CalibrationTRC AdjustmentAdjust Toner DensityIOTOutput DeviceFaultsMax SetupIISSInput DeviceSys-SystemSys-UserAdjustment / Others Machine ID / Billing DataTray 5(Bypass) GuideAdjustment (Tray 5=MPT)Measure IBT Belt SpeedInitialize HFSI Counterj0el6101a