Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-693WorkCentre 7132 078-210Status-indicator-rapsRevision078-210 TTM Tray 2 Lift RAPBSD-ON:7.11The Tray 2 Level Sensor did not actuate in time after the Tray 2 Feed/Lift Motor energized.Initial ActionsEnsure the tray is set up and loaded correctly.ProcedureExecute Component Control [072-001 or 002 Tray 2 Feed/Lift Motor ON]. The Tray 2 Feed/Lift Motor /PL 15.6) can be heard (the lifted paper plate drops when the tray is opened).Y NCheck the connections of P/J220B, P/J661B and P/J549. P/J220B, P/J661B and P/J549 are connected correctly.Y NConnect P/J220B, P/J661B and P/J549.Remove the Tray 1 Feed/Lift Motor (PL 2.3) and the Tray 2 Feed/Lift Motor (PL 15.6).Replace the Tray 2 Feed/Lift Motor with the Tray 1 Feed/Lift Motor.Execute Component Control [072-001/002 Tray 2 Feed/Lift Motor ON]. The Tray 2 Feed/Lift Motor can be heard (the lifted paper plate drops when the tray is opened).Y NReturn the Tray 1 Feed/Lift Motor to its original position.Check the wires between P/J220B and P/J549 for an open circuit or a short circuit(BSD 7.11 Flag 1). The circuit between P/J220B and P/J549 is conductingwithout an open circuit or a short circuit.Y NRepair the open circuit or short circuit.Replace the Tray Module PWB (PL 15.9).Return the Tray 1 Feed/Lift Motor to its original position.Replace the Tray 2 Feed/Lift Motor (PL 15.6).Check the installation of the Tray 2 Level Sensor (PL 15.6) and the operation of the actuator.The Tray 2 Level Sensor is installed correctly and the actuator works.Y NReinstall the Tray 2 Level Sensor (PL 15.6).Execute Component Control [072-103 Tray 2 Level Sensor]. Manually activate the Tray 2 LevelSensor (PL 15.6). The display changes.Y NCheck the connections of P/J101B, P/J611 and P/J549. P/J102A, P/J611 and P/J409are connected correctly.Y NConnect P/J101B, P/J611 and P/J549.Check the wires between P/J101B and P/J549 for an open circuit or a short circuit (BSD7.11 Flag 2 Flag 3). The wires between P/J101B and P/J549 are conducting withoutan open circuit or a short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Tray Module PWB P/J549-22 (+) and P/J549-23 (-)(BSD 7.11 Flag 3). The voltage is approx. +5VDC.Y NReplace the Tray Module PWB (PL 15.9).Measure the voltage between the Tray Module PWB P/J549-24 (+) and GND (-) (BSD7.11 Flag 2).Activate the actuator of the Tray 2 Level Sensor (PL 2.3). The voltage changes.Y NReplace the Tray 2 Level Sensor (PL 15.6).Replace the Tray Module PWB (PL 15.9).Check the paper transport drives and repair as required (PL 2.3, PL 15.9).AA