Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-707WorkCentre 7132 091-910, 091-911Status-indicator-rapsRevision091-910 Waste Toner Bottle Position RAPBSD-ON:9.9The Waste Toner Bottle is not in the correct position.ProcedureCheck the installation of the Waste Toner Bottle. Waste Toner Bottle installation is correct.Y NCorrect the installation problem by checking for damaged mounting points.Verify the condition of the circuit, BSD9.9, between the Waste Toner Position Sensor and MCUPWB. The circuit is free of damage.Y NRepair the circuit as required.Ensure the Waste Toner Bottle is installed correctly. Then check Waste Toner Bottle sensoroperating voltage and output. The signal level voltage indicates the Waste Toner Bottle iscorrectly installed.Y NThere is a problem with the sensor. Repair or replace the Waste Toner Position Sensor(PL 4.2).Replace the MCU PWB (PL 11.1).091-911 Waste Toner Full RAPBSD-ON:9.9The Waste Toner Bottle is full.ProcedureCheck the contents level of the Waste Toner Bottle. The Waste Toner Bottle is full.Y NVerify the condition of the circuit, BSD9.9, between the Waste Toner Bottle Sensor andMCU PWB. The circuit is free of damage.Y NRepair the circuit as required.Ensure the Waste Toner Bottle is installed correctly. Then check Waste Toner Bottle FullSensor operating voltage and output. The signal level voltage indicates the WasteToner Bottle is full.Y NReplace the MCU PWB (PL 11.1).There is a problem with the sensor. Repair or replace the Waste Toner Full Sensor (PL4.2).Replace the Waste Toner Bottle. If the problem persists, return to the beginning of the RAP.