Xerox WorkCentre 7132 Service Documentation

Also see for WorkCentre 7132: Quick use guide Setup guide Supplementary guide Paper guide Quick network setup guide

Contents

January 20072-116 WorkCentre 7132010-319, 010-320RevisionStatus-indicator-rapsY NReplace the Fuser Unit (PL 7.1).Check the resistance of the Rear Thermistor between P615-12 and P615-11 (BSD 10.2 Flag 3/Flag 2). The resistance is 3k ohms or higher.Y NReplace the Fuser Unit (PL 7.1).Check the wire between J422 and J615 for an open circuit or a short circuit (BSD 10.2 Flag 3/Flag 2). The wire between J422 and J615 conducts with less than a few ohms.Y NRepair the open circuit or short circuit.Check the wire between J5 and J615 for an open circuit or a short circuit (BSD 10.2 Flag 1).The wire between J5 and J615 conducts with less than a few ohms.Y NRepair the open circuit or short circuit.Check the wire between J409 and J513 for an open circuit or a short circuit (BSD 10.2 Flag 4).The wire between J422 and J615 conducts with less than a few ohms.Y NRepair the open circuit or short circuit.Replace the Fuser Unit (PL 7.1). If the problem persists, replace the Power Unit (PL 11.1). Ifthe problem persists, replace the MCU PWB (PL 11.1).010-320 Heat Roll Over Temperature RAPBSD-ON:10.2• The Control (Center) Thermistor detected a temperature higher than the specified value.• The Rear Thermistor detected a temperature higher than the specified value.Initial ActionsPower Off/OnProcedureNOTE: Ensure that NVM location 744-004 is set to zero (0). If the problem continues, replacethe Fuser Unit (PL 7.1)Check the resistance of the Control (Center) Thermistor between P615-5 and P615-9 (BSD10.2 Flag 3/Flag 2). The resistance is 3k Ohms or higher.Y NReplace the Fuser Unit (PL 7.1).Check the resistance of the Rear Thermistor between P615-11 and P615-12 (BSD 10.2 Flag 3/Flag 2). The resistance is 3k ohms or higher.Y NReplace the Fuser Unit (PL 7.1).Check the wire between J422 and J615 for a short circuit (BSD 10.2 Flag 3/Flag 2). The wirebetween J422 and J615 conducts with less than a few ohms.Y NRepair the open circuit or short circuit.Check the wire between J422 and J615 for an open circuit or a short circuit (BSD 10.2 Flag3Flag 2). The wire between J409 and J513 conducts with less than a few ohms.Y NRepair the open circuit or short circuit.Replace the Fuser Unit (PL 7.1). If the problem persists, replace the Power Unit (PL 11.1). Ifthe problem persists, replace the MCU PWB (PL 11.1).