2 Panel Operator2.1.1 Names and Functions2-22.1 Overview2.1.1 Names and FunctionsPanel operator consists of display part and keys.Setting parameters, displaying status, executing utility functions, and monitoring multi-winding drive unit orconverter operation are possible with the panel operator.The names and functions of the keys on the panel operator are as follows.2.1.2 Display SelectionPress the MODE/SET Key to make a selection in the following order. Multi-winding drive unitDisplay partKeysNote: To reset the servo alarm, press the UP Key and the DOWN Key simultaneously. Be sure to remove the causeand then reset the alarm.Key No. Key Name Function MODE/SET Key • To select a display.• To set the set value. UP Key To increase the set value. DOWN Key To decrease the set value. DATA/SHIFT Key • To display the set value by pressing this key for one second.• To move to the next digit on the left when flashing.Status Display (Refer to 2.3)Fn: Utility Function(Refer to 2.4)Pn: Parameter Setting(Refer to 2.6)Un: Monitor Display(Refer to 2.7)Power ONPressPress for one second.Press for one second.Press for one second.PressPressPressReturn toMODE/SETDATA/DATA/SHIFTMODE/SETMODE/SETMODE/SETDATA/DATA/SHIFTDATA/DATA/SHIFT(Refer to 2.2.)(Refer to 2.3.)(Refer to 2.4.)(Refer to 2.1.3.)Analog
