YASKAWA SGD7S-*A20**F62 Series Product Manual

Contents

6.2 List of Servo Parameters6-10Pn00A2 Application FunctionSelections A0000 to0044 – 0001 All Afterrestart Setup *1Pn00B2 Application FunctionSelections B0000 to1121 – 0000 All Afterrestart Setup *1Continued on next page.Continued from previous page.ParameterNo.SizeName SettingRangeSettingUnitDefaultSettingApplicableMotorsWhenEnabledClassi-ficationRefer-encen.XMotor Stopping Method for Group 2 Alarms0 Apply the dynamic brake or coast the motor to a stop (use the stoppingmethod set in Pn001 = n.X).1 Decelerate the motor to a stop using the torque set in Pn406 as the maximumtorque. Use the setting of Pn001 = n.X for the status after stopping.2 Decelerate the motor to a stop using the torque set in Pn406 as the maximumtorque and then let the motor coast.3 Decelerate the motor to a stop using the deceleration time set in Pn30A. Usethe setting of Pn001 = n.X for the status after stopping.4 Decelerate the motor to a stop using the deceleration time set in Pn30A andthen let the motor coast.n.XStopping Method for Forced Stops0 Apply the dynamic brake or coast the motor to a stop (use the stoppingmethod set in Pn001 = n.X).1 Decelerate the motor to a stop using the torque set in Pn406 as the maximumtorque. Use the setting of Pn001 = n.X for the status after stopping.2 Decelerate the motor to a stop using the torque set in Pn406 as the maximumtorque and then let the motor coast.3 Decelerate the motor to a stop using the deceleration time set in Pn30A. Usethe setting of Pn001 = n.X for the status after stopping.4 Decelerate the motor to a stop using the deceleration time set in Pn30A andthen let the motor coast.n.X Reserved parameter (Do not change.)n.X Reserved parameter (Do not change.)n.XOperator Parameter Display Selection0 Display only setup parameters.1 Display all parameters.n.XMotor Stopping Method for Group 2 Alarms0 Stop the motor by setting the speed reference to 0.1 Apply the dynamic brake or coast the motor to a stop (use the stoppingmethod set in Pn001 = n.X).2 Set the stopping method with Pn00A = n.X.n.XPower Input Selection for Three-phase SERVOPACK0 Use a three-phase power supply input.1 Use a three-phase power supply input as a single-phase power supply input.n.X Reserved parameter (Do not change.)