5.5 Base Mounting Units5-23 Peripheral Devices55.5.5 Mounting MethodMount the power regeneration converter and SERVOPACK to the base mounting units as described in thissection.As shown in the following figure, insert the heat sink on the power regeneration converter or SERVOPACKinto the base mounting unit and secure it with the enclosed screws (four).The side of the base mounting unit with the terminal block is the bottom of the unit.For instructions on installation in a control panel, refer to 6.2Σ-V-SD Driver.Model Size of Enclosed Screws Tightening TorqueJUSP-JUBM050AAM5 2.6 to 3.2 Nxm(23.0 to 28.3 lbfxin)JUSP-JUBM075AAJUSP-JUBM100AAJUSP-JUBM150AA
