2-14CABLE ROUTING DIAGRAM SPEC1 Ground lead2 Ignition coil lead3 Clamp4 Wireharness5 CDI magneto lead6 YPVS breather hose7 Radiator breather hose8 Cable guide9 “ENGINE STOP” button lead0 Brake hoseA Pass the “ENGINE STOP” but-ton lead on the inside of theignition coil lead and groundlead.B Clamp the “ENGINE STOP” but-ton lead, ground lead, ignitioncoil lead, wireharness and CDImagneto lead with the clampends downward.In so doing, clamp the “ENGINESTOP” button lead at its con-nector and do not allow the CDImagneto lead to slacken.Also make sure that the ignitioncoil lead is not pulled.C Pass the radiator breather hoseoutside the engine bracket andinside the down-tube.Pass theradiator breather hose insidethe CDI magneto lead.D Clamp the CDI magneto lead,radiator breather hose andYPVS breather hose. In sodoing, clamp the CDI magnetolead at the rear of the down-tubewith the clamp ends outward.E Clamp the radiator breatherhose and CDI magneto lead atthe rear of the down-tube withthe clamp ends outward.F Pass the radiator breather hoseand CDI magneto lead in frontof the radiator hose.G Pass the radiator breather hosebetween the frame and radiator.H Align the top of the brake hoseneck with the brake hose holderbottom.I Pass the brake hose in front ofthe axle boss,then fit it into thehose groove so that the brakehose does not contact the nut(wheel axle).J Fit the brake hose into the guideon the protector.
