Troubleshooting Methods449l Storage status (only applicable to T58V/T58A/T56A).l Dongle status (only applicable when DECT USB dongle DD10K is connected to the T58V/T58A/T56A).TopicViewing the Phone StatusViewing the Phone StatusYou can view phone status via phone user interface by navigating to Settings->Status.You can also view the phone status via the web user interface.Procedure1. Open a web browser on your computer.2. Enter the IP address in the browser’s address bar, and then press the Enter key.For example, “http://192.168.0.10” for IPv4 or “http://[2005:1:1:1:215:65ff:fe64:6e0a]” for IPv6.3. Enter the user name (admin) and password (admin) in the login page.4. Click Login to log in.The phone status is displayed on the first page of the web user interface.Phone RebootYou can reboot the IP phone remotely or locally.TopicsRebooting the IP Phone RemotelyRebooting the IP Phone via Phone User InterfaceRebooting the IP Phone via Web User InterfaceRebooting the IP Phone RemotelyYou can reboot the phones remotely using a SIP NOTIFY message with “Event: check-sync” header. Whether the IPphone reboots or not depends on “sip.notify_reboot_enable”. If the value is set to 1, or the value is set to 0 and theheader of the SIP NOTIFY message contains an additional string “reboot=true”, the phone will reboot immediately.The NOTIFY message is formed as shown:NOTIFY sip:@ SIP/2.0To: sip:@From: sip:sipsak@CSeq: 10 NOTIFYCall-ID: 1234@Event: check-sync;reboot=trueTopicNotify Reboot ConfigurationNotify Reboot ConfigurationThe following table lists the parameter you can use to configure notify reboot.
