3Com Switch 7750 SeriesCommand Reference Guide – AAA, RADIUS, HWTACACS, EADChapter 1 AAA & RADIUS & HWTACACSConfiguration Commands1-44Use the undo retry stop-accounting command to restore the default maximumnumber of transmission attempts of the buffered stop-accounting requests.Stop-accounting requests are critical to billing and will eventually affect the charges ofthe users; they are important for both the users and the ISP. Therefore, the NAS shoulddo its best to transmit them to the RADIUS accounting server. If the RADIUS serverdoes not respond to such a request, the switch should first buffer the request on itself,and then retransmit the request to the RADIUS accounting server until it gets aresponse, or the maximum number of transmission attempts is reached (in this case, itdiscards the request).Related command: reset stop-accounting-buffer, radius scheme and displaystop-accounting-buffer.Example# In RADIUS scheme radius1, specify that the switch can transmit a bufferedstop-accounting request at most 1,000 times<3Com>system-viewSystem View: return to User View with Ctrl+Z.[3Com] radius scheme radius1[3Com-radius-radius1] retry stop-accounting 10001.2.20 secondary accountingSyntaxsecondary accounting ip-address [ port-number ]undo secondary accountingViewRADIUS scheme viewParameterip-address: IP address, in dotted decimal notation. By default, the IP address of thesecondary accounting server is 0.0.0.0.port-number: UDP port number, ranging from 1 to 65535. By default, the UDP portnumber of the secondary accounting service is 1813.DescriptionUse the secondary accounting command to set the IP address and port number ofthe secondary RADIUS accounting server.Use the undo secondary accounting command to restore the default IP address andport number of the secondary RADIUS accounting server.See the description on the primary accounting command for details.
