V6100 and V7122 User Guide 229ini File Field NameWeb Parameter Name Valid Range and DescriptionISDNGeneralCCBehavior[General Call ControlBehavior]16 = The gateway clears down the call if it receives a NOTIFY messagespecifying ‘User-Suspended’. A NOTIFY (User-Suspended) message isused by some networks (e.g., in Italy or Denmark) to indicate that the remoteuser has cleared the call, especially in the case of a long distance voice call.32 = Applies only to ETSI E1 lines (30B+D). Enables handling thedifferences between the newer QSIG standard (ETS 300-172) and otherETSI-based standards (ETS 300-102 and ETS 300-403) in the conversion ofB-channel ID values into timeslot values:In ‘regular ETSI’ standards, the timeslot is identical to the B-channel IDvalue, and the range for both is 1 to 15 and 17 to 31. The D-channel isidentified as channel-id #16 and carried into the timeslot #16.In newer QSIG standards, the channel-id range is 1 to 30, but the timeslotrange is still 1 to 15 and 17 to 31. The D-channel is not identified aschannel-id #16, but is still carried into the timeslot #16.When this bit is set, the channel ID #16 is considered as a valid B-channelID, but timeslot values are converted to reflect the range 1 to 15 and 17 to31. This is the new QSIG mode of operation. When this bit is not set(default), the channel_id #16 is not allowed, as for all ETSI-like standards.ISDNOutCallsBehavior[Outgoing Calls Behavior]1024 = Numbering plan / type for T1 IPÆTel calling number are definedaccording to the manipulation tables or according to RPID header (default).Otherwise, the Plan / type for T1 calls are set according to the length of thecalling numberISDNIBehavior_x[Q.931 Layer ResponseBehavior]Same as the description for parameter ‘ISDNBehavior’ for a specific trunk ID(x = 0 to 7)ISDNInCallsBehavior_x[Incoming Calls Behavior]Same as the description for parameter ‘ISDNInCallsBehavior’ for a specifictrunk ID (x = 0 to 7)ISDNOutCallsBehavior_x[Outgoing Calls Behavior]Same as the description for parameter ‘ISDNOutCallsBehavior’ for a specifictrunk ID (x = 0 to 7)Channel ParametersThe Channel Parameters define the DTMF, fax and modem transfer modes. See Fax &Modem Transport Modes for a detailed description of Fax and Modem transfer modes; seeConfiguring the DTMF Transport Types for detailed description on DTMF transport modes.The Default Channel Parameters are applied to all V7122 channels.
