472 V6100 and V7122 User Guide Stop Bits = 1 Flow Control = None5 Insert the “Boot CD” (created in Stage 3) into the USB CD-ROM.6 Power up the V6100.7 On the Terminal screen, the BIOS phase will start and the Linux TM installation will begin.The installation will uncompress the kernel, load it and its drivers and start the interactiveinstallation.After the BIOS phase, some badly formatted text may appear on the screen.From this point on, you should proceed with the screen instructions, as instructedby your Linux distributor.Additional Linux™ Debian Installation Notes (14)Please see the following notes for the remaining part of the installation.1 The first interactive screen should be “Language Selection”. Before you select thelanguage you wish to use, remove the “Boot CD” and insert the 1st Debian installationdisk. Select the language you wish to use.2 As you continue with the installation, you should go through the following stages of theinstallation:a) Country selectionb) CROM scanc) DHCP configuring3 Configure your network settings manually by selecting the “Configure networkmanually” option. Either: the DHCP configuration will fail and a screen enabling you to configure the networkmanually will appear,or go to the Main Installation menu and select the manual network configuration.Ensure the network is connected and set a Static IP Address and all the othernetwork parameters.4 Continue with the installation, going through the following screens: “Partition disks” “Installing the Debian base system”5 At the “Install the GRUB boot loader on hard disk” screen, select “Go Back”. Thisreturns you to “Debian installer main menu” screen. This is the main menu of theinstallation.
