- - * $ $ , 3.7.3 Program CheckPressing 3 while viewing Maintenance Screen #1 will cause the following screen to bedisplayed:The Program Check feature allows the programmer to view the zones which have beenprogrammed to the Notification Appliance Circuits on the control panel but have not beenprogrammed to Initiating Devices as well as other circuits with no input or outputcorrelations. Pressing 1 while viewing Program Check screen will cause a screen similarto the following to be displayed.The example above indicates that NAC 1 has been programmed to Zones 25, 31, 44, 55and 67 but no input devices have been programmed to any of these zones. Use the up anddown arrow keys to view all the NAC zones without input assignments for both NAC 1and NAC2.Pressing 2 while viewing the Program Check screen will display a screen similar to thefollowing:The Zone No Input screen allows the programmer to view the zones which have not beenprogrammed to at least one input device (not including general alarm Zone 00). Theexample in the preceding screen indicates that Zones 05, 07, 09, 10 and 11 have beenprogrammed to an addressable module (control module in this example) with an addressof 001 on loop 1 but have not been programmed to any input devices. Use the up anddown arrow keys to view all the zones without input assignments.PROGRAMMING1=POINT PROGRAM2=HISTORY3=PROGRAM CHECKMaintenance Screen #1 @@@@PROGRAMCHECK1=NACS@NO@INPUT2=ZONES@NO@INPUT3=ZONE@NO@OUTPUTProgram Check Screen@@@NACS@NO@INPUTNAC@1@@@@25@31@44@55@67@@@ZONES@NO@INPUT05@07@09@10@11@1M001
