Master Programming Level ProgrammingUnimode 9600 PN 51336:C 11/06/01 833.6.4.5.2 TypeThe main circuit board NAC type can be programmed by pressing 2 while viewingNAC Screen #1. The following screens will be displayed:Select the NAC device type by pressing the number corresponding to the type in theappropriate screen as shown above. When the selection is made, the display willreturn to NAC Screen #1.The following table contains NAC type codes and their functions:3.6.4.5.3 SilenceablePressing 3 while viewing NAC Screen #1 will cause the display to change toSilenceable No. This will prevent the selected main circuit board NAC from beingsilenced by pressing the Alarm Silence key or by the Auto Silence feature. Each pressof the 3 key will cause the display to toggle between Silenceable Yes and SilenceableNo.Important: When a Notification Appliance Circuit with a mix of audible and visualdevices is programmed for silenceable and the synchronization feature is selected,only the audible devices will be turned off if the Silence key is pressed. The visualdevices (strobes, etc.) will continue to operate.NAC Type Code Special FunctionBell NoneHorn NoneStrobe NoneSynced Strobe Synchronized to manufacturerAudible NoneSiren Circuit NoneBlank NoneNAC #1=ENABLED2=TYPE3=SILENCEABLENAC Screen #1@@@@@@@NAC@TYPE1=BELL2=HORN3=STROBEType Screen #1@@@@@@@NAC@TYPE1=FUTURE2=SIREN CIRCUIT3=BLANKType Screen #2@@@@@@@NAC@TYPE1=SYNCED@STROBE2=FUTURE3=AUDIBLEType Screen #3
