- - * $ $ , 3.6.11 Clear ProgramPressing 2 while viewing Programming Screen #4, will select the Clear Program option.This will cause the LCD to display the following screens:Pressing 1, for Whole System while viewing the Clear Program Screen #1, will clear allgeneral system programming options and all programmed addressable devices from thenonvolatile memory of the FACP. This function is useful when the control panel is firstinstalled, prior to autoprogramming. Note that it is necessary to autoprogram after usingthe Clear Whole System function.Pressing 2, for All Loops while viewing the Clear Program Screen #1, will clear allprogramming related to all SLC loops and connected addressable devices.Pressing 3, for Loop 1 while viewing the Clear Program Screen #1, will clear only theprogramming related to SLC Loop 1 and the connected addressable devices.Pressing 1, for Loop 2 while viewing the Clear Program Screen #2, will clear only theprogramming related to SLC Loop 2 and the connected addressable devices.Before executing any of the Clear commands listed above, the control panel will provide awarning to the user by prompting with the following display:Pressing 1 will cause the control panel to carry out the selected clear option. Pressing 2will prevent programming from being cleared.PROGRAMMING1=PASSWORD CHANGE2=CLEAR PROGRAM3=LOAD PROGRAMProgramming Screen #4 @@@CLEAR@PROGRAM1=WHOLE@SYSTEM2=ALL@LOOPS3=LOOP1@@@CLEAR@PROGRAM1=LOOP2Clear Program Screen #1Clear Program Screen #2See Page@@@@@@WARNING!@@SYSTEM@CHANGE@@@@@PROCEED?1=YES@@@@@@@@@@@2=NO
