9 ) :' - "% Pressing the down arrow key, while viewing the screen shown above, will allow theoperator to view additional programming information about the selected device, such as:• Enable/Disable Status• Device Type• Alarm Verification On/Off• Walktest Yes/No• PAS (Positive Alarm Sequence) Yes/No• Pre-Signal Yes/No• Zone Assignments (five maximum)• Adjective/Noun descriptor4.22.2 ZonesPressing 2 while viewing Read Status Screen #1 will cause the following screens to bedisplayed:From the preceding screens, the control panel operator can view:• Zones Installed - all software zones programmed into the system (99 maximum)• Zones Enabled - all software zones that are enabled• Zones Disabled - all software zones that have been disabled• Special Purpose - on or off programming for Special Purpose Zones 97 reserved forPAS, 98 reserved for Pre-signal and 99 reserved for future use• Zone Type - the Type assigned to each installed zone (default is Alarm)READ STATUS1=SYSTEM POINT2=ZONES3=POWERRead Status Screen #1 ZONES1=ZONES INSTALLED2=ZONES ENABLED3=ZONES DISABLEDZones Screen #1ZONES1=SPECIAL PURPOSE2=ZONE TYPEZones Screen #2
