ADT Unimode 9600 Installation And Operating Instruction

Contents

ADT Unimode 9600 Installation And Operating Instruction Manual pdf 24 page image

Installation Mounting24 Unimode 9600 PN 51336:C 11/06/01SECTION 2 InstallationThe cabinet may be either semi-flush or surface mounted. The cabinet mounts using twokey slots and two 0.250” (6.35 mm) diameter holes located in the backbox. The key slotsare located at the top of the backbox and the two securing holes at the bottom.Carefully unpack the system and check for shipping damage. Mount the cabinet in aclean, dry, vibration-free area where extreme temperatures are not encountered. The areashould be readily accessible with sufficient room to easily install and maintain the panel.Locate the top of the cabinet approximately 5 feet (1.5 m) above the floor with the hingemounting on the left. Determine the number of conductors required for the devices to beinstalled. Sufficient knockouts are provided for wiring convenience. Select theappropriate knockout(s) and pull the conductors into the box. All wiring should be inaccordance with the National and/or Local codes for fire alarm systems.2.1 Mounting The circuit board contains static-sensitive components. Always ground yourself with aproper wrist strap before handling any boards so that static charges are removed from thebody. Use static suppressive packaging to protect electronic assemblies.✓ Mark and predrill holes in the wall for the top two keyhole mounting bolts usingthe dimensions illustrated in Figure 2.2 on page 25✓ Install two upper fasteners in the wall with the screw heads protruding✓ Using upper ‘keyholes,’ place backbox over the two screws, level and secure✓ Mark and drill the lower two holes✓ Mount backbox, install remaining fasteners and tighten✓ Screw supplied standoffs onto mounting studs in locations indicated below✓ When the location is dry and free of construction dust, install the main circuitboard by aligning the 10 mounting holes in the circuit board with the 10mounting standoffs in the backbox as illustrated below✓ Secure the circuit board to the standoffs with the supplied screws and male/female standoff as indicated in following figure!See Page+BATTERY-LCD DISPLAY KEYPAD I/FOPT DACTHOTCB1J3J2TB1 TB2TB3JP3JP2SW1JP5JP6J17 J16J6 J8J7JP10 JP11CUT TODISABLELOCALCHARGERDISABLEGNDFLTCUT TOMONITOR 4XTMOPT SLC4XTM OPT BDTB4 TB5 TB6 TB7 TB8NEUT EARTHFigure 2.1 Unimode 9600 Main Circuit Board InstallationUnimode 9600 BackboxUnimode 9600 Main Circuit Boardmounting studs mounting studs96brdmnt.cdrIMPORTANT!Secure circuit board to this standoffwith supplied male/female standoff