ADT Unimode 9600 Installation And Operating Instruction

Contents

ADT Unimode 9600 Installation And Operating Instruction Manual pdf 87 page image

*$$ , - - 1?3.6.5 AutoprogramPressing 2 while viewing Programming Screen #2, will select the Autoprogram option,which prompts the control panel to poll all devices installed on one or both SLC loops.The primary purpose of autoprogramming is to allow the installer a fast and easy way tobring the system on-line as quickly as possible. The first time the system is powered-up, itshould be autoprogrammed.If the system is already programmed and Autoprogram is initiated, the system will onlyadd default values for newly installed devices.When Autoprogram is selected, the programmer is given the option of autoprogrammingall loops, only loop 1 or only loop 2. The following will be displayed on the LCD:After selecting one of the Autoprogram options, the control panel will beginautoprogramming the system by communicating with each addressable device installed onone or both loops. While autoprogramming, the panel will display the following:When Autoprogramming is completed, the control panel will display the type and quantityof each device installed on the SLC loop(s) similar to the following display:In the preceding example, the first display indicates that Loop 1 has 55 addressabledetectors, 35 monitor modules and 30 control modules installed. The second displayindicates that Loop 2 has no devices installed.PROGRAMMING1=SYSTEM SETUP2=AUTOPROGRAM3=VERIFY LOOPSProgramming Screen #2@@@@AUTOPROGRAM1=LOOP@12=LOOP@23=ALL@LOOPSAutoprogram Loop Select Screen@@@@AUTOPROGRAM@@AUTOPROGRAMMING!@@@@PLEASE@WAITAutoprogram Progress Screen#@OF@DET@LOOP1@055#@OF@MON@LOOP1@035#@OF@CON@LOOP1@030#@OF@DET@LOOP2@000#@OF@MON@LOOP2@000#@OF@CON@LOOP2@000Autoprogram Result Screen #1Autoprogram Result Screen #2