ADT Unimode 9600 Installation And Operating Instruction

Contents

ADT Unimode 9600 Installation And Operating Instruction Manual pdf 75 page image

*$$ , - - ?3.6.4 System SetupSystem Setup allows the programmer to configure the following control panel features:• Trouble Reminder: This feature, when enabled, provides an audible reminder that analarm or trouble still exists on the FACP after the control panel has been silenced.The control panel piezo sounder will pulse once every 15 seconds during an alarmand every two minutes during a trouble condition, after the Alarm Silence orAcknowledge key is pressed. The piezo will continue to sound at these rates untilthe alarm or trouble condition is cleared. If the trouble condition is not clearedwithin 24 hours, the panel will reactivate the trouble sounder and retransmit thetrouble condition to the central station if connected.• Banner: This option allows the user to change the top line of the LCD display fromthe factory default readout to a user defined readout when the control panel is inNormal condition.• Time-Date: This feature allows the programmer to set the time, display format (24hr or 12 hr), date and daylight savings time feature into the FACP memory• Timers: This option allows the programmer to set the PAS (Positive AlarmSequence) time delay, Pre-Signal time delay and Waterflow time delay.• NACs: This feature allows the programmer to configure the two control panelNotification Appliance Circuits for a variety of options, such as circuit type,silenceable/nonsilenceable, autosilence, coding, silence inhibit, zone assignmentand enable/disable.• Relays: This option allows programming of two onboard relays for activation byvarious control panel events, such as alarm, trouble, supervisory, etc.Pressing 1 for System Setup, while viewing Programming Screen #2, will cause thefollowing screens to be displayed:3.6.4.1 Trouble Reminder "( 2 , " %" % ' ' . " G( 'I , "( 9 , ' ( % + 2 , 7$!$ "'7 '- ?9 , % ' , , " + - ( ) & )-$! $ "' $% A ) %" '! -- 9 9 )%( , " + <% ' , ( * ! ) %" '! -- ( ) 9 9 +PROGRAMMING1=SYSTEM SETUP2=AUTOPROGRAM3=VERIFY LOOPSProgramming Screen #2@@@@SYSTEM@SETUP1=TROUBLE@REM@@@@OFF2=BANNER3=TIME-DATESystem Setup Screen #1@@@@SYSTEM@SETUP1=TIMERS2=NAC3=RELAYSSystem Setup Screen #2See Page