* $ $ , - - 3.7.6 Zone SetupPressing 3 while viewing Maintenance Screen #2 will display the following screen:Pressing 1 while viewing Zone Setup screen will display the following screen:A flashing cursor appears to the right of the Z. To enable a zone, enter the two digit zonenumber (00 - 99). After the second digit is entered, the zone will be enabled and thecursor will return to the original position. The next zone to be enabled can then beentered. Press Esc (Escape) to return to the previous screen.Pressing 2 while viewing Zone Setup screen will display the following screen:A flashing cursor appears to the right of the Z. To disable a zone, enter the two digit zonenumber (00 - 99). After the second digit is entered, the zone will be disabled and thecursor will return to the original position. The next zone to be disabled can then beentered. Press Esc (Escape) to return to the previous screen.PROGRAMMING1=WALKTEST2=SYSTEM3=ZONE SETUPMaintenance Screen #2 @@@@ZONE@SETUP1=ENABLE2=DISABLE3=ZONE@97@98@99Zone Setup Screen@@ZONE@TO@ENABLEZEnable ScreenZONE TO DISABLEZDisable Screen
