|
:' - "% ) & • Second line in display:✓ ; refers to the user programmed adjective descriptor from library listresident in the control panel or custom entry via PC.✓ ; refers to the user programmed noun descriptor from library listresident in the control panel or custom entry via PC.• Third line in display: Z000 indicates the zone programmed to this device which, inthis example, is general alarm Zone 000. Note that a single device can beprogrammed to five different zones but only the first zone will be displayed.• Fourth line in display:✓ Time; the current time in this example is 10:00A which represents 10:00 AM✓ Date; the current month, day and year in this example is 01 for January, 08 for the8th day of the month and 01 for the year 2001✓ Device Address; 1M001 in this example 1 represents SLC Loop1, M represents amodule and 001 represents device address 0014.6 Supervisory OperationSupervisory operation is similar to alarm operation but with the following differences:• The piezo sounder pulses ½ second On and ½ second Off• The Supervisory LED flashes ½ second On and ½ second Off• The LCD displays the status label Active Supervisory along with the device name,type, address, adjective/noun, associated zones and time/date• The supervisory relay is activated• The alarm relay is not activated• Silenced alarms are not resounded• Timers are not started• Store event in history bufferA typical Supervisory event would be displayed as illustrated in the following:Note that, like alarms, supervisory signals latch (except when programmed forsupervisory autoresettable) and can be assigned to software zones. Supervisory alarms donot cause resound as do other alarm conditions. Open circuits in supervisory wiring areprocessed by the control panel the same way as other trouble conditions. Refer to "AlarmOperation" on page 109, for a description of the information displayed on the controlpanel LCD.ACTIVE SUPERVISORY Z00010:00A 010801 1M001
PreviousNext |