- - * $ $ , 1 3.7.1 Disable PointPressing 1 for Point Program, while viewing Maintenance Screen #1 will cause thefollowing screens to be displayed:Select the Loop, containing the device to be disabled, by pressing 1 for Loop 1 or 2 forLoop 2. A screen will then be displayed, allowing the operator to select the type ofaddressable device to be disabled as shown in the following display:Select the device type by pressing 1 for an addressable detector or 2 for an addressablemodule. The operator will be prompted to enter the three digit device address as shown inthe following example for a detector:A flashing cursor will appear in the bottom left corner of the display, prompting for thethree digit device address. When the third digit is enter, 001 for example, a screen willappear which will allow enabling or disabling of the selected point, as illustrated in thefollowing example:Pressing 1 repeatedly will cause the display to toggle between Enabled Yes and EnabledNo.PROGRAMMING1=POINT PROGRAM2=HISTORY3=PROGRAM CHECKMaintenance Screen #1 @@POINT@PROGRAM1=LOOP@12=LOOP@2Loop Select Screen@@POINT@PROGRAM1=DETECTOR2=MODULEDevice Select Screen@EDIT@DETECTORENTER@POINT@ADDRESS***Address Select ScreenEDIT@DETECTOR@1D0011=ENABLED@@@@@@@@YESEnable/Disable Select Screen
