3. Disconnect the red positive (+) cable from thevehicle with the good battery.4. Disconnect the red positive (+) cable from theother vehicle.5. Return the remote positive (+) terminal coverto its original position.Headlamp AimingThe vehicle has a visual optical headlamp aimingsystem. The aim has been preset at the factoryand should need no further adjustment.However, if the vehicle is damaged in an accident,the headlamp aim may be affected and adjustmentmay be necessary.If oncoming vehicles flash their high beams atyou, this may also mean the vertical aim needs tobe adjusted.It is recommended that the vehicle is taken to yourdealer for service if the headlamps need to bere-aimed. It is possible however, to re-aim theheadlamps as described in the following procedure.Notice: To make sure your headlamps areaimed properly, read all the instructions beforebeginning. Failure to follow these instructionscould cause damage to headlamp parts.The vehicle should be properly prepared as follows:• The vehicle should be placed so the headlampsare 25 ft. (7.6 m) from a light colored wall.• The vehicle must have all four tires on a levelsurface which is level all the way to the wall.• The vehicle should be placed so it isperpendicular to the wall.• The vehicle should not have any snow, ice, ormud on it.• The vehicle should be fully assembled and allother work stopped while headlamp aiming isbeing performed.• The vehicle should be normally loaded with afull tank of fuel and one person or 160 lbs(75 kg) sitting on the driver’s seat.• Tires should be properly inflated.• The spare tire is in its original location inthe vehicle.389
