228 Understanding the Printer MenusNFC AuthenticationNOTE: The NFC Authentication feature is available on the Dell Cloud Multifunction Printer | H815dw only.Purpose:To specify whether to enable the authentication using the NFC authentication card.Values:FIPS 140-2 Validation ModeNOTE: The FIPS 140-2 Validation Mode feature is available on the Dell Smart Multifunction Printer | S2815dn only.Purpose:To specify whether to use the FIPS 140-2 Level-1 approved encryption algorithms for RSA modules.Values:NOTE: Communication using the following protocols will not be encrypted using FIPS 140-2 Level-1 approved encryptionalgorithms even when FIPS 140-2 Validation Mode is enabled. Users are advised to turn them off manually when FIPS 140-2Validation Mode is enabled:• SNMP v3• SMB• PDF Direct PrintNOTE: This feature may not be available for certain models.USB SettingsUse the USB Settings menu to change printer settings affecting a USB port.USB PortNOTE: USB Port feature is available only for the USB port on the rear of the printer.Purpose:To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then onagain.Values:PS Data FormatPurpose:To specify PostScript 3 Compatible communication protocol. You can configure the PS Data Format settings. Thechange becomes effective after the printer is turned off and then on again.Disable* Does not permit the authentication using the NFC authentication card.Enable Permits the authentication using the NFC authentication card.Disable* Allows the use of FIPS 140-2 Level-1 unapproved algorithms.Enable Allows the use of FIPS 140-2 Level-1 approved encryption algorithms.Disable Disables the USB interface.Enable* Enables the USB interface.
