Installing Optional Accessory 496Installing Optional AccessoryThis chapter describes how to install the optional 550-sheet feeder (tray2).NOTE: The images used in this manual are those of the Dell™ Cloud Multifunction Printer | H815dw unless otherwise mentioned.Installing the Optional 550-Sheet FeederWARNING: If you install the optional 550-sheet feeder after setting up the printer, be sure to turn off the printer, unplug thepower cable, and disconnect all cables from the rear of the printer before starting this task.NOTE: The Software and Documentation disc also contains video instructions. In the main menu window of Dell Printer EasyInstall, click Installation Video.1 Ensure that the printer is turned off, and then disconnect all cables from the rear of the printer.2 Remove the tape and the bag holding the screws.NOTE: Save the screws as you will need them later.3 Place the optional 550-sheet feeder in the same location that the printer is located.4 Gently pull open the MPF cover.5 Grasp both sides of the MPF, and then pull the MPF from the printer.
