dot1x reauthentication [interval] secondsThe range is from 1 to 65535.The default is 3600.• Configure the maximum number of times the supplicant can be re-authenticated.INTERFACE modedot1x reauth-max numberThe range is from 1 to 10.The default is 2.Example of Re-Authenticating a Port and Verifying the ConfigurationThe bold lines show that re-authentication is enabled and the new maximum and re-authentication time period.Dell(conf-if-Te-1/1)#dot1x reauthentication interval 7200Dell(conf-if-Te-1/1)#dot1x reauth-max 10Dell(conf-if-Te-1/1)#do show dot1x interface TenGigabitEthernet 1/1802.1x information on Te 1/1:-----------------------------Dot1x Status: EnablePort Control: FORCE_AUTHORIZEDPort Auth Status: UNAUTHORIZEDRe-Authentication: EnableUntagged VLAN id: NoneTx Period: 90 secondsQuiet Period: 120 secondsReAuth Max: 10Supplicant Timeout: 30 secondsServer Timeout: 30 secondsRe-Auth Interval: 7200 secondsMax-EAP-Req: 10Auth Type: SINGLE_HOSTAuth PAE State: InitializeBackend State: InitializeAuth PAE State: InitializeBackend State: InitializeConfiguring TimeoutsIf the supplicant or the authentication server is unresponsive, the authenticator terminates the authentication process after 30seconds by default. You can configure the amount of time the authenticator waits for a response.To terminate the authentication process, use the following commands:• Terminate the authentication process due to an unresponsive supplicant.INTERFACE modedot1x supplicant-timeout secondsThe range is from 1 to 300.The default is 30.• Terminate the authentication process due to an unresponsive authentication server.INTERFACE modedot1x server-timeout secondsThe range is from 1 to 300.802.1X 101